Winter Feed Estimator is a great tool for cow/calf producers

News
Nov 8, 2013
by WLJ

Estimating winter feed needs now will save beef cow/ calf producers from running out of feed during a time when feed prices are the highest to purchase.

The number one cost for beef cow-calf producers is feed, more specifically, mechanically harvested winter feed.

Estimating the amount of forage that will be needed and then matching that with the amount of feed identified in a feed inventory will help cowcalf producers avoid running out. Determining how much feed will be needed and the current feed inventory will allow producers to decide if there will be feed shortage problems. If feed resources do not match feed requirements, producers will need to decide if they are going to reduce animal numbers or purchase additional feed resources. Now is the time to make those calculations. One very easyto-use tool is the Winter Feed Estimator from the University of Florida.

The Winter Feed Estimator (http://edis.ifas.ufl.edu/pdf files/AN/AN24400.pdf) is a very quick and easy way to determine how much feed is needed for the herd. The dry matter (DM) requirements will be based on frame size, and number of weeks a producer plans to feed. Knowing the frame size is critical in order to accurately estimate the amount of dry matter required. The amount of time that the animals will be fed is also critical; the less time you feed stored feeds, the lower your costs will be, thus the more money you will be making. Employing practices to extend the grazing season and utilize crop residues are excellent opportunities to reduce the quantity of stored feed required for winter feeding.

There are four steps involved in using the Winter Feed Estimator:

1. Determine the frame size;

2. Determine the number of cattle that are going to be fed;

3. Estimate the required weeks cattle will be fed;

4. Convert dry matter tons to bales of dry hay, baleage or other feed sources.

Dry matter requirements are based on 2.5 percent of mature body weight. Frame sizes are as follows: small frame cattle will weigh between 950-1,050 pounds; medium frame cattle will weigh between 1,100-1,200 pounds; and larger frame cattle will weigh between 1,250-1,350 pounds. For example, a 1,200-pound cow would fall into the medium frame category and her daily DM intake would be (1,200 x 0.025 = 30) 30 pounds of dry matter per day. Next, it is necessary to convert the DM figure to an as-fed figure. That is done by dividing the amount of DM by the percentage of DM in the stored feed. An example of this is: (30/0.85 = 35.2) so, the cow would need to consume approximately 35 pounds of hay (15 percent moisture) per day. The Winter Feed Estimator helps producers make these conversions. Producers will find that they may need to run through this exercise several times to come up with different scenarios depending upon the number of cows that will be kept and the amount of time that they will be fed.

It is important to note that it would not be feasible to consider and cover all of the scenarios that can account for the variability in forages. Nutrient value of the forages can vary greatly. The Winter Feed Estimator assumes that the forages will be adequate to meet the nutritional needs of the cattle. Michigan State University Extension recommends performing a forage analysis to determine nutrient content and moisture level. Storage and feeding methods also play an important role in feeding the cow herd.

For more information on using the Winter Feed Estimator, or other questions related to your beef herd, contact Kable Thurlow at:

989-426-7741 ext. 107, or thurlowk@anr.msu.edu , or one of the other Michigan State University Extension educators in the state. — Michigan State University Extension

{rating_box}